A rapid-setting, two-component, moisture insensitive, high modulus, structural epoxy bonding gel. SpecPoxy 3000 FS is 100% solid, solvent-free, low odor, high strength and non-sag. ASTM C-881, Type I, II, IV, V, Grade 3, Class B & C SpecPoxy

(click image to enlarge)

Quick Overview

Surface preparation is critical prior to applying epoxies. Surfaces to be bonded must be clean and structurally sound. Remove all oil, grease, dirt, laitance, curing compounds, and any other foreign matter. This includes bolts, rebar or threaded rod. All drilled holes must be cleaned out with a nylon brush. Remove dust and loose material. Use clean, oil free compressed air to blow out any remaining water, dust, or debris prior to application.
Epoxies must be proportioned and mixed at the correct ratios. If the ratio is incorrect, performance of the cured epoxy may drop and/or the epoxy will not cure and set up.
Thoroughly mix Part A and B separately. Then mix Part A and Part B together thoroughly for three minutes with a low speed motor using a Jiffy mixer or paddle. Mix only as much material as can be used within the pot life
When extending epoxy with aggregate always use clean, dry aggregate.
Epoxies are very temperature dependent. High temperatures will accelerate set times and low temperatures will slow down set times.

Interested in this item or want more information?
Call Mon. through Fri. 7:30 AM - 4:00 PM MST
Phone: (303) 825-8555
Email: chris@contractorssupply.com

Can't find what you want? Give us a call and we can help you find it.

Additional Information

Manufacturer: Spec Chem

Search: